Three Lume tiles in green can give a wall three different looks. A narrow brick creates direction, a square makes an even grid and a raised tile catches the light across its surface. If you’re planning a kitchen splashback or a bathroom basin wall, compare the shape and texture against the fittings that will sit alongside them.
The Lume Green brick for a directional layout

The 60 × 240 mm Lume Green is a gloss porcelain tile with a long, narrow shape. Lay it horizontally to carry the eye along a run of worktop, or stack it vertically to draw attention upwards behind a basin. If you want an offset pattern, ask your tiler to sketch the joints around a socket, the edge of a mirror or the end of a worktop.
The brick is a good starting point if you want the tile layout to pick up an existing line in the room, such as the height of a shelf or the edge of a cabinet.
View Green in the Lume Tiles range (NB16942)
The Lume Green square for an even grid

Lume Square Green is a 100 × 100 mm gloss porcelain tile. Its square grid gives a short wall section an even rhythm in both directions. Try it above a narrow vanity if you want the joints to frame the basin without emphasising the width or height of the wall.
Mark the basin centreline, then sketch the difference between centring a tile and centring a grout joint. The two arrangements leave different cuts at the edges, especially on a short run.
View Green in the Lume Square range (NB26117)
Lume Green 3D Rake for a textured feature

The 60 × 240 mm Lume Green 3D Rake is also gloss porcelain. Its raised profile makes light and shadow part of the design. Compare it with the rectangular Lume Green tile if you want to keep a similar layout and give one section of the wall more detail.
Hold a sample where you intend to use it, with the room lights on. Try it near a side light as well as under overhead lighting. If you are pairing the two rectangular tiles, ask your tiler to check the actual thickness and how the edges will meet before setting out the join.
View Green 3D Rake Structure in the Lume Rake Tiles range (NB17988)
Compare the samples together
Put the three samples against the wall with your worktop or vanity finish close by. Look at them in daylight and again with the lights you’ll use in the evening. If you’re mixing formats, check how the shades look together and plan exactly where the change in format will fall. Measure each tiled section separately so you can calculate how much of each format you need, including cuts.

